Tremron Home Additions & ADU Nationwide

Tremron Home Additions & ADU: The San Jose Owner’s Guide

We stock and install Tremron-compatible hardscape components for home additions and ADU projects in San Jose, with typical installed pricing for full addition work running $53,100-$153,400 and ADU construction at $106,200-$259,600. Most Tremron paver and retaining wall inquiries we see involve settling, drainage failure, or expansion-joint separation after 5-10 years of Silicon Valley’s clay-heavy soil cycles. Measure twice, permit once, then we talk timeline.

Call (669) 271-8644

San Jose homeowners usually discover the problem during seasonal inspection: pavers that were flush in May have shifted into a trip hazard by October, or the retaining wall that held back the Willow Glen hillside is showing weep holes clogged with adobe runoff. The failure rarely announces itself dramatically; it accumulates.

Which Tremron Models This Applies To

Tremron’s residential hardscape line divides into three series relevant to San Jose additions and ADUs: the Olde Towne cobble-style pavers (common in Almaden Valley courtyard additions), the Stonehurst slate-faced modular system (frequent in Japantown ADU walkways), and the Retaining Wall split-face units used for grade changes in the foothill neighborhoods near Alum Rock. Each series carries a stamped manufacturing date and batch code on the pallet edge; for in-place identification, measure the face dimension to the nearest eighth inch, Olde Towne runs 6×6 and 6×9 nominal, Stonehurst 6×12 and 12×12, retaining wall units 8×18 face.

The OEM-versus-aftermarket question for Tremron specifically hinges on color match. Tremron’s Sierra and Terra Cotta blends are proprietary; aftermarket equivalents from Belgard or Techo-Bloc (which we also stock) can run within a shade but rarely nail the exact iron-oxide variation after three years of San Jose sun exposure. For repairs under 40 square feet, we source factory-matched Tremron. For full rebuilds where the original lot is discontinued, we document the closest live-match alternative in writing before ordering.

Signs Your Tremron Home Additions & ADU Is Failing

• Pavers rock underfoot or have separated at the joints. The bedding sand has washed out, usually from a failed edge restraint or inadequate slope away from the structure. In the Rose Garden neighborhood, we regularly see this where downspouts dump directly onto walk surfaces without a splash block.
• White powder blooms on the paver face after rain. This is efflorescence, mineral salts migrating through the concrete matrix. It’s cosmetic but signals moisture moving through the system rather than draining, which will degrade the bedding layer over cycles.
• Retaining wall leans or shows stair-step cracking at the corners. The footing has shifted or the drainage aggregate behind the wall is clogged with native clay. San Jose’s expansive soils make this a predictable failure mode on walls built without geogrid reinforcement in the lower courses.
• Water pools on the surface more than 30 minutes after irrigation or rain. The original pitch has reversed, often from root heave (common with established valley oaks) or substrate settlement. The fix is not sealing; it’s regrading and relaying.
• Chipping or spalling at the paver edges, especially near garage thresholds. De-icing salt or fertilizer runoff has attacked the surface, or the wrong paver thickness was specified for the load. Tremron’s 60mm units handle passenger vehicles; 80mm is required for truck or RV pads.

Before

After

Replacement Cost & What’s Included

For Tremron hardscape work tied to a home addition or ADU in San Jose, pricing breaks into two scopes. Repair and relay of existing Tremron surfaces runs $4,720-$15,340 depending on square footage, substrate condition, and whether we need to match discontinued color lots. New installation as part of a full addition or ADU build falls within the broader project ranges: home additions at $53,100-$153,400, ADU construction at $106,200-$259,600.

What drives the spread: soil prep depth (12 inches minimum for vehicular, 6 inches for pedestrian), drainage infrastructure (perforated pipe and washed rock behind retaining walls), and permit complexity. San Jose’s Planning Division requires site plans for any retaining wall over 4 feet, and ADUs trigger separate utility tie-in inspections. Our quote itemizes each line: demolition, export, base rock, bedding sand, pavers, edge restraint, joint sand, and sealer if specified. Under Clause 1 of the Haven Standard, that written price is delivered before any work starts. The 365-Day Done Right Promise covers the installation; manufacturer defects on the Tremron product itself are handled through Tremron’s limited lifetime warranty.

DIY or Call Us?

An owner can safely assess what’s failing: photograph the pattern of settlement, check the edge restraint for visible gaps, and verify whether downspouts or irrigation heads are directing water under the surface. What goes wrong in DIY is the substrate. Hand-tamping and all-purpose sand work for about 18 months in San Jose’s climate, then the clay underneath heaves and the surface mirrors it.

Retaining walls over 30 inches carry genuine collapse risk if the drainage layer is omitted or the base course isn’t leveled to within a quarter inch. We’ve rebuilt three Willow Glen walls in the past two years where the homeowner’s initial stack looked sound but lacked geogrid and perforated drainage. For a documented photo record and a written price before anyone lifts a paver, call (669) 271-8644.

FAQs